Water Pump Removal And Installation - Suzuki GF60A Service Manual

3A-6 Right Hand Rotation Unit:
6) Connect the clutch rod and the shift rod using the
clutch rod connector in the following procedure:
NOTE
The clutch rod connector is not a turnbuckle
but just a long nut with right-hand thread.
a) Screw the clutch rod connector (4) onto the
clutch rod (5) all the way to the end of its thread.
b) Screw the lower nut (6) onto the shift rod (7) all
the way to the end of its thread.
c) Locate the shift cam at Neutral position by
moving shift rod (7) up or down and then hold it
at the position.
d) While holding the clutch control lever (8) and
shift cam at neutral position, screw the clutch rod
connector (4) onto the shift rod (7) until the
connector contacts the lower nut (6).
5
4
6
7
e) With the clutch rod connector (4) securely held,
tighten the lower nut (6) firmly against the
connector.
7) Shift the clutch control lever to "Forward" and
"Reverse" position from "Neutral" position to check
proper gear engagement.
5
4
6
7
IAJ311310008-01
8
N
IAJ611310009-01

Water Pump Removal and Installation

Removal
1) Remove the lower unit. Refer to "Lower Unit
Removal and Installation" (Page 3A-5).
2) Loosen four nuts (1), then remove water pump case
(2).
3) Remove impeller (3), impeller key (4) and pump
under plate (5).
Keep impeller key (4) for reuse and discard the plate
gasket.
5
NOTE
To facilitate the removal of inner sleeve from
pump case, warm up the entire case using a
heater like hair dryer.
4) Remove inner sleeve (6) and rubber seal ring (7).
6
ZAJ6113106005
1
2
IAJ611310010-01
3
4
IAJ611310011-01
7
IAJ611310012-01