Power Trim And Tilt Unit Disassembly - Suzuki GF60A Service Manual

2B-17 Power Trim and Tilt:

Power Trim and Tilt Unit Disassembly

NOTE
Before disassembly, wash the PTT body with
a stiff bristle brush and hot, soapy water to
remove sand or dirt. Dry the PTT body with
compressed air.
1) Place the lower section of the PTT unit in a vise.
Tighten the vise only enough to secure the PTT unit,
DO NOT OVER TIGHTEN.
NOTE
To prevent damage to the PTT cylinder use
wood blocks, vise jaw protectors, etc.,
between the vise jaws and PTT components
before tightening vise.
2) Connect the PTT cable extension to PTT motor
cable connector.
Special tool
(A): 09945–79310 (PTT cable extension)
3) Connect the PTT cable extension leads (G, Bl) to
battery and operate PTT motor until tilt rod is at
maximum stroke (full-tilt up position). Unscrew the
filler plug and drain PTT oil into a suitable container.
(A)
4) Remove the manual release valve snap ring (1),
ZAJ6112206007
then unscrew the manual release valve (2).
5) Remove the PTT motor assembly (3).
Refer to "Power Trim and Tilt Motor Removal and
Installation" (Page 2B-22).
Note the position of drive joint (4) and O-ring (5),
before removing them.
IAJ611220038-01
6) Remove the filter (6).
I9J011220011-01
1
5
2
IAJ611220039-01
3
4
IAJ611220040-03
6
IAJ611220041-01