Power Trim And Tilt Motor Disassembly And Assembly - Suzuki DF70A Service Manual

Installation
Installation is reverse of removal with special attention to
following steps.
• Ensure that the drive joint (1) is aligned and firmly
inserted into the gear pump assembly.
• Fit O-ring (2) to PTT motor.
2
1
3
• Check the level of PTT fluid contained in the PTT
pump assembly. If level is low, add recommended
PTT fluid until level with mating surface of PTT motor.
• Ensure that the faces of the PTT motor and pump unit
are free of dirt or debris.
When attaching the PTT motor to the PTT pump
assembly (3), ensure that the tip of armature shaft (4)
fits firmly into the drive joint (1).
• Tighten the four screws (a) to specified torque.
Tightening torque
PTT motor screw (a): 5 N·m (0.5 kgf-m, 3.6 lbf-ft)
(a)
• Pour recommended PTT fluid into reservoir until
specified level.
• Perform the air bleeding procedure.
Refer to "Power Trim and Tilt Unit Reassembly"
(Page 2B-19).
4
I9J011220032-02
(a)
I9J011220033-02
Power Trim and Tilt Motor Disassembly and
Assembly
Disassembly
1) For correct assembly, scribe an alignment mark on
the field case and brush holder.
2) Slide cable protector tube upward.
3) Remove the screw securing the motor cable holder
(1), then slide motor cable holder and grommets (2)
out as shown in figure.
1
4) Remove the two screws (3) securing the field case to
the brush holder.
5) Slide the field case upward and away from the brush
holder.
NOTE
When separating field case from brush
holder, push the PTT motor cables into brush
holder as the field case is removed.
Power Trim and Tilt: 2B-23
Z9J0112206010
2
1
I9J011220034-01
3
I9J011220035-01
I9J011220036-01