Rectifier/Regulator Inspection - Suzuki GF60A Service Manual

1K-7 Charging System:

Rectifier/Regulator Inspection

Inspect the rectifier/regulator in the following procedures:
1) Remove the ring gear cover.
Refer to "Ring Gear Cover Removal and Installation" in Section 1D (Page 1D-2).
2) Disconnect all lead wires of rectifier/regulator.
3) Measure resistance between terminals in the combinations shown.
If measurement exceeds specification, replace rectifier/regulator.
NOTE
The values given below are for a SUZUKI pocket tester.
As thyristors, diodes, etc. are used inside this rectifier/regulator, the resistance values will differ when
an ohmmeter other than SUZUKI pocket tester is used.
Special tool
: 09930–25002 (Pocket tester)
Tester knob indication
Resistance (x 1 kΩ)
Rectifier and regulator resistance
Tester probe ( )
(Black)
connection
W B
Y Y Y
1 2 3
Tester probe ( ) (Red) connection
IAJ6111B0002-02
ZAJ6111B06006
Unit: k
: Infinity
IAJ6111B0003-01