Throttle Body Removal And Installation - Suzuki GF60A Service Manual

1D-10 Power Unit Mechanical:

Throttle Body Removal and Installation

Removal
1) Remove the starter motor and air intake silencer
case.
Refer to "Starter Motor Removal and Installation" in
Section 1I (Page 1I-6).
2) Remove the silencer holder (1).
1
3) Remove the three bolts (2) and remote control
harness connector holder (3).
2
3
4) Remove the throttle link rod (4) from throttle body.
ZAJ6111406008
IAJ611140073-01
IAJ611140074-01
4
IAJ611140075-01
5) Remove the four bolts (5) securing throttle body to
intake manifold, then detach the throttle body.
6) Disconnect the MAP / throttle position / IAT sensor
lead wire connector (6) at sensor.
6
5
Installation
Installation is reverse order of removal with special
attention to the following steps.
CAUTION
Do not reuse gaskets, always replace with
new one.
• Clean mating surface and install the seal ring (1).
• Install the throttle body (2), then securely tighten the
four throttle body bolts to specified torque.
Tightening torque
Throttle body bolt (a): 10 N·m (1.0 kgf-m, 7.2 lbf-
ft)
2
IAJ611140076-02
1
IAJ611140077-01
(a)
IAJ611140078-01