Clamp / Swivel / Steering Brackets Disassembly - Suzuki GF60A Service Manual

2A-22 Housing and Bracket:

Clamp / Swivel / Steering Brackets Disassembly

1) Remove engine holder / oil pan and driveshaft
housing. Refer to "Engine Holder / Oil Pan /
Driveshaft Housing / Mounts Disassembly" (Page
2A-13).
2) Remove screw and bonding wire from lower mount
bracket.
3) Remove circlip (1).
4) Remove lower mount bracket (2), shims (3), and
washer (4) from the steering shaft.
2
5) Lift steering bracket (5) upward to remove from
ZAJ6112106011
6) Remove swivel bracket seal (8) and lower bushing
IAJ611210078-01
1
7) Remove bolt (10) and trim sensor assembly (11).
IAJ611210079-01
4
3
8) Slide the lower trim sensor cam plate (12) off.
IAJ611210080-02
swivel bracket.
Remove washer (6) and upper bushing (7).
(9).
Cut the cable tie securing sensor lead wire.
5
6
7
IAJ611210081-01
9
8
IAJ611210082-01
10
11
IAJ611210083-01
12
I9J011210088-01