Engine Holder / Oil Pan / Driveshaft Housing / Mounts Related Component Inspection - Suzuki GF60A Service Manual

Water Pressure Valve
• Install water pressure valve (1) and cover (2).
Refer to "Water Pressure Valve Removal and
Installation" in Section 1F (Page 1F-4).
1
Bonding Wire
• Reattach the bonding wire (1), then tighten screw
securely.
Engine Holder / Oil Pan / Driveshaft Housing /
Mounts Related Component Inspection
Refer to "Engine Holder / Oil Pan / Driveshaft Housing /
Mounts Disassembly" (Page 2A-13) and "Engine Holder
/ Oil Pan / Driveshaft Housing / Mounts Assembly" (Page
2A-15).
NOTE
If any component is found to be excessively
worn, cracked, defective or damaged in any
way, it must be replaced.
2
I9J011210052-01
1
IAJ611210069-01
ZAJ6112106006
Housing and Bracket:
Engine Holder
• Inspect the engine holder. Replace if cracked,
damaged, or other abnormal conditions are noted.
• Check water passage. If clogged or obstructed, clean
water passage.
Mount Case Cover
• Inspect the mount case cover. Replace the mount
case cover if cracked, damaged or other abnormal
conditions are found.
• Check condition of O-ring. Replace O-ring if nicked,
cut, worn or other abnormal condition.
• Check condition of oil seal. Replace oil seal if nicked,
cut, worn or other abnormal condition are found.
NOTE
Install oil seal with lip (spring side) facing
downward (oil pan side).
2A-19
IAJ611210070-01
IAJ611210071-01