Low Pressure Fuel Pump Removal And Installation; Low Pressure Fuel Pump Inspection - Suzuki GF60A Service Manual

1G-26 Fuel System:
Low Pressure Fuel Pump Removal and
Installation
NOTE
The low pressure fuel pump is a non-
repairable component.
Do not attempt to disassemble the low
pressure fuel pump.
It must be replaced as a complete unit if it is
defective.
Removal
1) Disconnect the inlet hose (1) and outlet hose (2)
from low pressure fuel pump (3).
2) Remove two bolts (4).
4
3
4
3) Remove fuel pump. Note the position before
removing the O-ring (5).
5
Installation
Installation is in the reverse order of removal with special
attention to the following steps.
CAUTION
• Before installing the fuel pump, rotate the
crankshaft to bring the No.1 (top cylinder)
piston to Top Dead Center on the
compression stroke.
• Do not reuse O-ring once removed. Always
use a new O-ring.
ZAJ6111706014
2
1
IAJ611170063-01
IAJ611170064-01
Tightening torque
Low pressure fuel pump bolt (a): 10 N·m (1.0 kgf-m,
7.2 lbf-ft)
(a)
(a)

Low Pressure Fuel Pump Inspection

NOTE
The low pressure fuel pump is a non-
repairable component.
Do not attempt to disassemble the low
pressure fuel pump.
It must be replaced as a complete unit if it is
defective.
Fuel Pump Assembly
Inspect the fuel pump.
If leakage, cracks, damage or other abnormal condition
is found, replace fuel pump assembly.
IAJ611170065-01
ZAJ6111706015
I9J011170071-01
I9J011170072-01