Power Trim And Tilt Unit; Removal - Suzuki DF 90 Service Manual

8-4 POWER TRIM AND TILT

POWER TRIM AND TILT UNIT

REMOVAL

Raise engine to the full tilt position and lower manual tilt lock
levers 1.
During the following procedures, the engine must be
firmly secured and its weight fully supported. (See right)
1. Remove tilt rod snap ring 2 and push tilt cylinder upper
shaft pin 3 out.
2. Lower tilt rod to full down position and disconnect battery
cable.
3. Disconnect PTT motor cable wire leads (Green, Blue) from
PTT motor relays.
4. Remove PTT motor cable from engine lower cover.
5. Remove STBD motor mounting bolts 4 and clamp
bracket shaft nut 5.