Battery Charge Coil Inspection; Rectifier/Regulator Removal And Installation - Suzuki GF60A Service Manual

Battery Charge Coil Inspection

Measure battery charge coil resistance in the following
procedure.
1) Remove the ring gear cover.
Refer to "Ring Gear Cover Removal and Installation"
in Section 1D (Page 1D-2).
2) Disconnect battery charge coil leads from rectifier/
regulator.
3) Measure resistance between leads in the
combinations shown.
If measurement exceeds specification, replace
battery charge coil.
Special tool
: 09930–99320 (Digital tester)
Tester knob indication
Resistance (Ω)
Battery charge coil resistance
Terminal for tester probe connection
Y1 to Y2
Y2 to Y3
Y3 to Y1
Y Y Y
1 2 3

Rectifier/Regulator Removal and Installation

ZAJ6111B06004
Removal
CAUTION
Prior to removing electrical parts, disconnect
battery cables from battery.
1) Remove the ring gear cover.
Refer to "Ring Gear Cover Removal and Installation"
in Section 1D (Page 1D-2).
2) Disconnect lead wire connector (1) from rectifier/
regulator.
3) Remove the bolts (2) and rectifier/regulator (3).
Resistance
0.48 – 0.72 Ω
Installation
1) Install rectifier/regulator (1), then tighten bolts (2)
securely.
2) Connect lead wire connector to rectifier/regulator.
Check that lead wire routed properly.
I9J0111B0005-02
Charging System:
3
2
1
2
1K-6
ZAJ6111B06005
1
IAJ6111B0014-01
IAJ6111B0015-01