Service Instructions; Spark Plug Removal And Installation; Spark Plug Inspection; Ignition Coil Removal And Installation - Suzuki GF60A Service Manual

1H-6 Ignition System:

Spark Plug Removal and Installation

Refer to "Spark Plug Removal and Installation" in
Section 0B (Page 0B-6).

Spark Plug Inspection

Refer to "Spark Plug Inspection and Cleaning" in Section
0B (Page 0B-7).

Ignition Coil Removal and Installation.

Removal
1) Disconnect the battery cables at the battery.
2) Remove the two bolts and fuel hose guard (1).
3) Disconnect the ignition coil connector (2).
4) Remove the bolt (3) securing the ignition coil, then
pull out the ignition coil (4).
Installation
1) Install the ignition coil, then secure the ignition coil
with its mounting bolt.
2) Connect the ignition coil connector.
3) Connect the battery cables to battery.

Service Instructions

ZAJ6111806001
ZAJ6111806002
ZAJ6111806003
1
IAJ611180005-01
3
4
2
IAJ611180006-01

Ignition Coil Inspection

NOTE
The ignition coil power transistor and high
tension lead are an integral part of the coils
internal circuit. Using resistance
measurements to check for a defect on either
the primary or secondary coil is not possible.
Special tool
: 09930–99320 (Digital tester)
Tester knob indication
DCV
1) Turn the ignition key OFF.
2) Disconnect the ignition coil connector.
3) Check for continuity between the GND (–) terminal
on the wiring harness side connector and the engine
body ground.
4) Turn the ignition key to the ON position. Check for
battery voltage by measuring between the BAT (+)
terminal and GND terminal on the wiring harness
side connector.
ZAJ6111806004