[Cme6] Call Forwarding Set/Reset From Mat/Cat - NEC NEAX 2000 IVS Command Manual

COMMAND CODE
E6
1. FUNCTION:
This command sets/resets the Call Forwarding service to each station from a MAT/CAT.
2. PRECAUTION:
CME6 can be used for any station irrespective of its state.
3. ASSIGNMENT PROCEDURE:
+ E6YY +
ST DE
4. DATA TABLE:
YY MEANING
00 Call Forwarding-All Calls
01 Call Forwarding-Busy Line
02 Call Forwarding-No Answer
03 Call Forwarding-Busy Line/
No Answer
04 Split Call Forwarding-All Calls
05 Split Call Forwarding-Busy Line/No
Answer
Note: To reset Call Forwarding, assign "CCC" to the second data.
[CME6] Call Forwarding Set/Reset From MAT/CAT
TITLE:
CALL FORWARDING SET/RESET FROM MAT/CAT
STATION No.
+ +
DE
(1-4 digits)
• Destination = Extension;
X-XXXX: Station No. (1-4 digits)
• Destination = Outside party;
X-XX+ , +YY...YY
• Destination = Attendant; E000
0: Target station for Split Call Forwarding (Block 0)/ATT
1: Target station for Split Call Forwarding (Block 1)
2: Target station for Split Call Forwarding (Block 2)
3: Target station for Split Call Forwarding (Block 3)
4: Target station for Split Call Forwarding (Block 4)
5: Target station for Split Call Forwarding (Block 5)
6: Target station for Split Call Forwarding (Block 6)
7: Target station for Split Call Forwarding (Block 7)
8: Target station for Call Forwarding
9: Station Speed Dialing (Block 0)
ND-45669 (E)
Addendum-002
JANUARY, 1999
DESTINATION No.
+
(1-26 digits) (for reset)
DESTINATION No.
Called No. (Max. 26 digits)
Separator Mark
Outgoing Trunk/LCR Group Access Code (1-2
digits)
CCC
+
EXE
CHAPTER 3
Revision 2.2
CME6
Page 349