NEC NEAX 2000 IVS Command Manual page 102
Hide thumbs
Also See for NEAX 2000 IVS:
- Installation manual (173 pages) ,
- User manual (81 pages) ,
- System manual (54 pages)
Table of Contents
Advertisement
COMMAND CODE
08
BASIC SERVICE FEATURE
204
Diversion display by ATTCON.
205
LDN Diversion by ATTCON.
(See CM58)
206
Trunk to Trunk Transfer by an Attendant before answer (on
the OG trunk).
208
Dialing of a Single Digit Feature Access Code, while the call-
ing station hears busy tone.
212
When a caller encounters all ACD/UCD stations busy.
214
When an ACD/UCD station dials the ACD/UCD Busy out
code after holding the call from a Tie Line or CCSA line.
(See CM17 Y = 6)
215
When an ACD/UCD station dials the ACD/UCD Busy out
code after holding the call from a C.O. Line (DDD/FX/
WATS).
(See CM17 Y = 5)
216
Designation of the processor to be checked for Authorization
Code/Forced Account Code.
217
Designation of the processor to be checked on a Direct Inward
System Access (DISA ID Codes).
221
Tone sent to all parties on a three party conference.
(Australia Only)
222
To complete the operation for setting the Call Forwarding-All
Calls-Outside Busy Line-Outside/No Answer-Outside.
227
Whether the transferred C.O. call from a station or ATTCON
is placed into queuing mode when all ACD/UCD stations are
busy (effective only when CM08 – 212 is set to 1).
228
Ringing start time for wake-up call/Timed Reminder call.
TITLE:
BASIC SERVICE FEATURES
ND-45669 (E)
Addendum-001
AUGUST, 1998
SETTING DATA
0
Available
1
Not available
0
Available
1
Not available
0
Available
1
Not available
0
Available
1
Not available
0
Busy Tone is to be sent out.
1
Caller is placed into queuing mode.
0
ACD/UCD station hears Service Set
Tone, and returns to the call by Switch
Hook Flash.
1
The call is disconnected.
ACD/UCD station hears ROT.
0
ACD/UCD station hears Service Set
Tone, and returns to the call by Switch
Hook Flash.
1
The call is disconnected.
ACD/UCD station hears ROT.
0
MP (PN-CP00) Basic (CM2A Y= 0-4)
1
AP (PN-AP01)
0
MP (PN-CP00) Basic (CM2A Y= 5-8)
1
AP (PN-AP01) Expanded (CM05)
0
Tone is not sent.
1
Every 4 sec.
0
Setting when the station goes on-hook/
when receiving Service Set Tone
(ORT Time Out).
1
Setting when receiving Service Set
Tone (ORT Time Out).
0
The call is placed into queuing mode.
1
Recall to the transferring station (when
the call is transferred from station) or
Attendant Camp-On is set (when the
call is transferred from ATTCON).
0
Start at preset time.
1
Start at the time 5 minutes before pre-
set time.
CM08
Initial Data
:
CHAPTER 3
Page 79
Revision 2.1
Advertisement
Table of Contents
