[Cm71] Memory Allocation For System Speed Dialing - NEC NEAX 2000 IVS Command Manual

CM71
COMMAND CODE
71
MAT
1. FUNCTION:
This command is used to allocate memory area for System Speed Dialing to tenants, attendants and Hot
Line outside stations.
2. PRECAUTION:
(1) System Speed Dialing has 300 memory locations system-wide; this is referred to as a "Memory
Block" (see figure below). Each location where a dialed number is stored is called a "Memory
Slot".
Example: The System Speed Dialing memory is assigned to three tenants as follows:
TENANT
00
01
02
(2) Limitation on Memory Slot allocation:
• In a single-tenant system, Tenant 00 can be assigned a maximum of 300 memory slots.
• Per Tenant:
• For Hot Line outside Call:
• For Route Advance from Tie Line to C.O. line:
CHAPTER 3
Page 240
Revision 2.0
[CM71] Memory Allocation for System Speed Dialing
TITLE:
MEMORY ALLOCATION FOR SYSTEM SPEED DIALING
Memory Block
QUANTITY OF SLOTS
20
15
10
ND-45669 (E)
Memory Slot
000
001
299
RANGE OF SLOT NUMBERS
Maximum of 300 memory slots
Maximum of 100 memory slots (maximum num-
ber of Hot Lines)
Maximum of 64 memory slots (maximum number
of Trunk Routes)
000 - 019
020 - 034
035 - 044