[Cm35] Trunk Route Data - NEC NEAX 2000 IVS Command Manual

COMMAND CODE
35
MAT
(2) When assigning a Tie Line, the data in YY = 09 (Incoming Call Signaling System) should be simi-
lar to that of YY = 20 (Sender Starting Condition). The following table shows the assignment of the
Sender Starting Condition in relation to the Incoming Call Signaling System.
INCOMING CALL
SIGNALING SYSTEM (YY = 09)
Ground Start (01)
Loop Start (15)
Wink Start (03)
Delay Dial (04)
Immediate (05)
2nd DT/Timing (06)
Note: ( ) indicates the data to be assigned.
(3) This command is included in MAT mode menu "B2" (Trunk Route data [COM01]).
3. ASSIGNMENT PROCEDURE:
ST + 35YY/YYY + DE +
TITLE:
TRUNK ROUTE DATA
SENDER STARTING CONDITION
(YY = 20); ( ) = data to be assigned
TRUNK ROUTE
(2 digits)
ND-45669 (E)
Ground Start (02)
Loop Start (15)
Wink Start (00)
Delay Dial (01)
Timing Start (15)
Timing Start (15)
DATA
+ DE +
(1-4 digits)
CM35
REMARKS
+ EXE
CHAPTER 3
Page 161
Revision 2.0