NEC NEAX 2000 IVS Command Manual page 104

COMMAND CODE
08
BASIC SERVICE FEATURE
250 Destination of Priority Call 0.
251 Destination of Priority Call 1.
252 Maximum number of digits in Station Speed Dialing.
253 Ring transfer for Call Transfer-All Calls to a Trunk (when a
station holds another station).
254 Whether the HOLD key of the Multiline Terminal is used as
the Call Party-Tenant-Set key for an internal or external call.
255 Name Display-Station/Trunk and Guest Name Display on
Multiline Terminal and ATTCON.
258 Selects when ORT will be released
(Forced Account Code and Authorization Code)
259 Warning tone sent to connected parties when monitoring a
station-to-station or a station-to-trunk call.
262 Multiline Terminal ringer volume control and sending of
Ring Test Tone
• To ring the ringer: depress
• To adjust the ringer volume: depress
264 Destination selection method for Day/Night Mode change,
when a Direct Inward Dialing Call terminates.
265 Display of Busy Out from UCD Group on DSS Console.
267 H/M feature (Wake-up, Do Not Disturb, Message Waiting,
Room Cut Off) records printout on the H/M printer, and a re-
port is sent to PMS when setting or resetting the H/M feature
from H/M Console or Administration Station.
TITLE:
BASIC SERVICE FEATURES
FNC
and dial 0.
or
ND-45669 (E)
0 Same station as Off-Hook Alarm.
(See CM51 YY = 12)
1 Terminate to ATTCON.
(See CM46 -54)
0 Same station as Off-Hook Alarm.
(See CM51 YY = 12)
1 Terminate to ATTCON.
(See CM46 -55)
0 26 digits - 3000 buffers
1 16 digits - 4500 buffers
0 Available
1 Not available
0 Call Park-Tenant-Set key
1 HOLD key
0 Not provided
1 To provide
0 When user presses recall key
1 When station goes on hook
0 Not sent
1 To send (only once)
Note 1
0 Available
1 Not available
.
0 For tenant of each DID incoming LDN
assigned by CM76 Y = 4
1 For tenant of station or trunk
(as per the data CM08 - 058)
0 To provide
1 Not provided
0 Available
1 Not available
Initial Data
:
SETTING DATA
CHAPTER 3
Revision 2.0
CM08
Page 81