Figure 3-32: Measurement Cal Factors Menu; Figure 3-33: Output Cal Factors Menu - Ametek CSW5550 User Manual

User Manual
3.11.13 MEASUREMENT CAL FACTORS Menu
The MEASUREMENT CAL FACTORS menu provides access to the measurement calibration
parameters. The parameters shown are for the mode of operation (AC or DC) selected. The
PHASE key must be used to toggle between the calibration screens for each of the three
phases. These parameters are password protected and can only be changed after the
calibration password has been entered. Refer to the calibration section in this manual for details
on performing a calibration.
The following calibration factors are available from this menu:
Entry
VOLT FS
CURR FS
3.11.14 OUTPUT CAL FACTORS Menu
The OUTPUT CAL FACTORS menu provides access to the output calibration parameters.
These parameters are password protected and can only be changed after the calibration
password has been entered. For three phase configurations, the PHASE keys toggle between
the three calibration screens for each phase. Refer to the calibration section in this manual for
details on performing a calibration.
The following calibration factors are available from this menu:
Entry
VOLT FS
V HI-FREQ
VOLT ZERO
PHASE OFST
CSW Series

Figure 3-32: MEASUREMENT CAL FACTORS menu

Description
Full scale voltage measurement calibration factor. AC or DC
mode.
Full scale current measurement calibration factor. AC or DC
mode.

Figure 3-33: OUTPUT CAL FACTORS menu

Description
Full scale voltage output calibration factor.
High frequency full-scale voltage output calibration factor.
Zero offset voltage calibration factor.
Phase offset calibration factor. Compensates for phase shift
caused by AC amplifier.
California Instruments
81