Ametek CSW5550 User Manual page 23

User Manual
Parameter
Front Panel Trigger,
BNC connector
Front Panel Phase
A, B and C, BNC
connectors
External Signal
External Gain
Control (RPV)
/INHIBIT
MOD
Trigger Input
External Synch
2.1.6 Unit Protection
Parameter
Input Overcurrent:
Input Overvoltage:
Input Overvoltage
Transients:
Output Overcurrent:
Output Short Circuit:
Overtemperature:
CSW Series
System Specification (continued)
Specification
Output available at the front panel BNC connector that provides a
negative going pulse for any programmed voltage or frequency
change. The trigger can be reassigned as an output when running list
transients.
These three outputs are representative of the programmed output
waveform, magnitude and frequency. 0 to 4.86 Vrms represents 0 to a
full-scale output voltage. The output impedance is 100 ohms.
Individual inputs for an external signal for each of the three phases. A 0
to 5.0 Vrms input provides a 0 to full-scale output voltage of the supplied
waveform
Individual inputs for an external DC signal for each of the three phases. A
0 to ±7.07 VDC signal provides a 0 to full-scale output voltage.
A logic Lo or contact closure input to inhibit the outputs
An input for an amplitude modulation. 0 to 5 Vrms provides 0 to ≥20%
modulation for each of the three output phases
An input to trigger a function
A TTL input to frequency synchronize the outputs. The Phase A output
can be programmed relative to the external input.
Specification
Circuit breaker with current trip control.
Automatic trip of input circuit breaker.
Surge protection to withstand EN50082-1 (IEC 801-4, 5) levels.
Adjustable level constant current mode with a maximum set point
between 0% and 10% above programmed value.
Peak and rms current limit.
Automatic shutdown.
California Instruments
23