Ametek CSW5550 User Manual page 15

User Manual
2.1.2 Output
(ALL SPECIFICATIONS ARE FOR AC AND DC UNLESS NOTED OTHERWISE)
Function
Calibration Interval
Power Factor of Load
AC or DC Output
Voltage
Output Current Per
Phase
Crest Factor
Output Frequency
Frequency Resolution
( Without CLock/Lock
option enabled)
Frequency Accuracy:
Output Power
AC Noise Level
Voltage Program and
Measurement
Accuracy
Voltage Program
resolution
Voltage Stability
Voltage Distortion
Load Regulation
Line Regulation
Phase Accuracy
Resistive Load
Phase Program
Resolution
External Amplitude
Mod
External Direct Input
DFI output
CSW Series
1 year
0 lagging to 0 leading
0 to 156 VRMS L-N range ; 0 to 312 VRMS L-N range
16A to 115V in 156V range; 8.0A to 230V in 312V range (1850 VA maximum).
Multiply current by the number of sources in a multiple power source system
3.25 (peak output current to RMS output current).
DC, or 40 Hz to 5 kHz
16.00 - 81.91 Hz (0.01 Hz resolution)
81.0 – 819.1 Hz (0.1 Hz resolution)
820 – 5000 Hz (1 Hz resolution)
±0.01% at 25ºC ±0.001%/ºC
1850 VA, maximum, per phase
>60 dB RMS below full output (sine wave, 40 to 500 Hz).
±0.1% of range. Above 1 kHz, add 0.2%/kHz. Add ±0.1% of full scale for "AC
PLUS DC" mode. Valid for 5 to 156 VRMS and 10 to 312 VRMS at 25°C
(77°F), sense leads connected. Temperature coefficient less than 50 ppm/°C
0.1 V from Front Panel
0.01 V from remote programming
±0.1% of full scale over 24 hours at constant line, load and temperature.
(Measured at Remote Sense point)
0.25% maximum, 40 to 100 Hz; 0.5% maximum to 500 Hz; and 1% maximum
to 1 kHz plus 1%/kHz to 5 kHz (Full linear load or No load)
±0.025% of full scale voltage for a full resistive load to no load; above 1 kHz,
add ±0.015%/kHz
±0.025% of full scale for a ±10% input line change.
±1º, 40 to 1 kHz plus ±1º/kHz above 1 kHz
±0.1º
0 to 5 VRMS provides 0 to 20%(±2% of full scale output)
0 to 5 VRMS (DC to 5 kHz) for 0 to full-scale output (±2% of full scale output to
3 kHz. ±2% from 3 kHz to 5 kHz). Limited to ±7.25 Vpeak
Contact closure to indicate: Loss of AC line and indication of various Status
that can be remotely programmed.
Specification
California Instruments
15