Ametek CSW5550 User Manual page 174

User Manual
8.9.4 Remote PROGRAMMING
The following SCPI command will be used to control the WHM functions:
WHMeter:
[STATe]
ETIMe?
WHOur?
WHMeter[:STATe]
This command will start or stop the watt-hour function.
Command Syntax
Parameters
Examples
Query Syntax
Returned Parameters
WHMeter:ETIMe?
This command will return the total amount of time the watt-hour meter accumulated. The
returned data has four fields separated by commas. These fields are hours, minutes, seconds
and milliseconds.
Command Syntax
Parameters
Query Syntax
Returned Parameters
WHMeter:WHOur?
Phase Selectable
This command will return the total accumulated kilowatt-hour for the selected phase. If coupling
is set to all, the value returned is the sum of all phases in the system irregardless of the selected
phase.
Command Syntax
Parameters
Query Syntax
Returned Parameters
: If the watt-hour meter is active, the total power of all phases in the system will be
Note
returned when querying the power.
174
Turn on or of the watt hour function
Return the elapse time
Return the watt-hour in KWH
WHMeter[:STATe]<bool>
0 | OFF | 1 | ON
WHM ON
WHM[:STATe]?
0 | 1
WHMeter:ETIMe?
none
WHM:ETIM?
h,mm,ss,ms
WHMeter:WHOur?
none
WHM:WHO?
<numeric value>
California Instruments
CSW Series