16) Check Of Wiring - Rotax 914 F Maintenance Manual

12.3.16) Check of wiring

— Check all cable plugs and connections for tight fit and good contact.
— Check all shorting connections for corrosion.
— Check plug connections between pick-up cable and electronic module
— Check plug connections between electronic module and ignition coils.
— Check plug connections of generator cables with rectifier-regulator and
— Check shorting cables for tight fit.
— Check shielding of cable assemblies for damage, perfect ground contact
— Inspect all 8 ignition cables to spark plug connector for damage and tight
— Verify tight plug connections of cable assy, on Turbo Control Unit (TCU)
Modification no.
- 0 -
and of charging and shorting cables.
connections of all cables on rectifier-regulator for good contact and tight fit.
and attachment of shielding.
fit. Check resistor plug connector for tight fit on spark plug.
on 2 pressure sensors, rev-counter pick-up, throttle potentiometer, air box
temperature sensor, servo motor, isolating switch, control valve and on
the two lamps.
Reference Main Date
914 F 1997 02 01
Page
105