Electric System; Check Of Wiring - Rotax 914 Series Maintenance Manual

6) Electric system

6.1)

Check of wiring

- Inspect all cable connectors and their connections for tight fit, good contact,
corrosion or damage and replace as necessary.
- Inspect all ground connections for corrosion and damage, replace if neces-
sary.
- Inspect plug connections between pick-up cable, electronic module, charg-
ing and shorting cables for corrosion or damage and replace as required.
- Inspect plug connections between electronic module and ignition coils for
corrosion or damage and replace if necessary.
- Verify plug connections of alternator cables with rectifier-regulator and
connections of all cables on rectifier-regulator for good contact, tight fit,
corrosion or damage and replace if necessary.
- Inspect grounding cables for tight fit, corrosion or damage and replace if
necessary.
- Verify shielding of cable assemblies for corrosion or damage, good ground
contact and tight fit, inspect the attachment of the shielding and replace if
necessary.
- Inspect all 8 ignition cables to spark plug connector for corrosion or damage
and tight fit and replace if necessary.
- Inspect plug connections of the wiring harness, of the turbocharger control
unit (TCU), 2x pressure sensors, tacho-generator, throttle potentiometer,
airbox temperature sensor, servo motor, disconnector, control valve and the
two lamps for corrosion or damage and tight fit and replace as necessary.
Effectivity: 914 Series
Edition 1 / Rev. 0
BRP-Rotax
MAINTENANCE MANUAL
12-00-00
page 43
May. 01/07