6) Oil Tank - Rotax 914 F Maintenance Manual

13.2.6) Oil tank

11
9
4
13
00077
8
Page Date
148 1997 02 01
See Pic. 101.
Detach oil tubes. Remove banjo screw Q M10 and hose nipple W with
sealing rings 10x14.
Loosen profile clamp E and remove oil tank cover R with O-ring T.
Disassemble internal parts of oil tank like baffle insert Y and partition U.
Remove oil drain screw I and sealing ring 10x18 w.
Clean all parts.
Check oil inlet O, oil outlet P (towards oil cooler/oil pump), venting nipple
{, oil return } (turbo) and suction tube q for free passage and for damage.
Visually check all parts of oil tank.
Re-assembly of oil tank in reversed sequence of disassembly.
Fit oil drain screw M12x12 with new sealing ring, tighten to 25 Nm (225 in.lb).
Secure with safety wiring.
1
2
10
12
5
Main
914 F
Tightening torque of banjo screw Q
17 Nm (150 in.lb).
WARNING:
After re-installation of the engine en-
sure no air is trapped in the lubrica-
tion system. For correct procedure,
see Chapter 13.2.10).
3
6
Pic. 101
7
Reference Modification no.
- 0 -