9) Loctite "574 Orange; 10) Loctite "380 Black; 11) Loctite "648 Green; 12) Loctite "221 Violet - Rotax 914 F Maintenance Manual

11.7.9) LOCTITE "574 orange"

11.7.10) LOCTITE "380 black"

11.7.11) LOCTITE "648 green"

11.7.12) LOCTITE "221 violet"

11.7.13) MICRONORM shot blasting abrasive

11.7.14) Lapping fleece SR 4600 A - very fine grading

Date
Page
1997 02 01
78
Is a sealing material used as alternative to conventional solid gaskets where
a high friction factor and exactly defined distance between parts is required.
LOCTITE sealing compound is a solvent-free liquid gasket applied to the
sealing surfaces. After assembly it cures under hermetical conditions with
metal contact within several hours. This gives a sealing completely adapted
to the surface structure of the parts to be sealed.
Its surface sealing properties are guaranteed for temperature range between
- 55°C and + 200°C (- 67°F to + 390°F). No corrosion is possible in the sealing
gap.
Adhesive suitable for materials of different properties. Suitable for medium
duty connections. Its cure time depending on the materials is max. 12 hours
and it resists temperatures from -55° C (- 67°F) up to +150° C (300° F).
Heavy duty adhesive or screw securing agent. Its cure time depending on the
materials and temperatures is max. 12 hours and it resists temperatures from
-55° C (- 67°F) up to +175° C (347° F). To separate parts secured by this agent,
it may be necessary to heat the parts to approx. 250° C (480° F).
Medium duty adhesive or screw securing agent suitable for materials of
different properties. In case of strain the stress is distributed evenly over the
whole surface of connection. The adhesive connection creates hermetic
sealing for gas and liquids. This sealing property protects the parts from
corrosion.
LOCTITE 221 is suitable for screws and nuts up to M12 threads and for low
duty connections.
This abrasive is suitable for local and gradual very fine treatment of steel parts
with rust film (propeller shaft). The MICRONORM shot blasting abrasive does
not contain any noxious matter, is approved by the competent authorities and
warrants for optimum cleaning. The granulates used are of sizes 40 to 60 µ.
The surface roughness to be achieved is 0,5 - 1 µ representing a microfinish
of the parts.
Is sold by the meter and used for manual removal of smaller rust spots or
oxidation, especially for optimum ground connections. It is most appropriate
to remove LOCTITE from surfaces or threads to make them metallic clean.
Before re-applying LOCTITE, clean surfaces with nitro-thinner or degreasing
agent (CASTROL ZA 30 or OMV - SOFT SOL). When using solvents, mind
the safety regulations for persons and environments.
Main
914 F
Reference Modification no.
- 0 -