Visually check the sealing surfaces. Clean oil duct P with
compressed air and check for free passage. Check dimen-
sion of bore { (dimension E) of bearing bush for crank-
shaft support },(dimension R) , see Chapter 15).
dimensions
See Wear Limits, Chapter 15).
00084
Modification no.
- 0 -
NOTE:
The crankshaft bearings in the ignition
housing are lubricated via the oil duct I.
Sealing of the oil duct at the joining face
between crankcase and ignition hous-
ing is by an O-ring O 5x2.
NOTE:
At the backside of the ignition housing a
thrust washer of the intermediate starter
gear may stick.
R
Reference
new
wear limit
E
Pic. 113
00382
Main
Date
914 F
1997 02 01
I
O
Pic. 112
Page
155