4) Application Of The Communication Program - Rotax 914 F Maintenance Manual

Page Date
198 1999 01 01
c) Procedure for installation of the communication program on the PC
Make sure of, which TCU and thus which program is the applicable one.
For TCU 966.470 use prog43 and for TCU 966.741 use prog46.
Switch on the PC and wait for message C:\>.
NOTE: If this message should not appear (e.g. immediate start of a
Windows-version) change over to MS-DOS level.
To establish the directory designated as 914/progxx enter the command
Insert program diskette into the drive "A" and enter the command
(enter only bold face printed command).
NOTE: With this command the directory "914" with all its sub
directories will be established.
Remove diskette from drive and store safety.
ATTENTION: Perform installation of the program every time with the
original diskette.

13.6.1.4) Application of the communication program

a) Start of the program:
establish connections PC∅ ∅ ∅ ∅ ∅ Dongle∅ ∅ ∅ ∅ ∅ TCU
switch on TCU
WARNING: Ensure engine ignition "OFF" and secured against uninten-
tional "ON".
switch on PC (if not active already)
start of the program direct from MS-DOS by call.
To start the program enter with command line
or
NOTE: If only the message C:\> appears start the program with the
same command line but in bold face print
Main
914 F
MD 914\progxx [Enter]
C:\>XCOPY A:*.* C:\ 914\progxx\ /s [Enter]
C:\914\prog43\>tlr43a [Enter]
C:\914\prog46\>tlr46a [Enter]
C:\>914\prog43\tlr43a [Enter]
C:\>914\prog46\tlr46a [Enter]
Reference Modification no.
- 3 -