13) Re-Assembly Of Ignition Electric Set - Rotax 914 F Maintenance Manual

13.4.13) Re-assembly of ignition electric set

00407
Magnetseite /
magneto side
Propellerseite /
propeller side
Pic. 142
Page Date
178 1997 02 01
Renewal of double ignition coils
At renewal of a double ignition coil, the following dismantling procedure is
required:
Remove hex. nut M6 { and rubber buffer } with bracket q. Remove the
Allen screw M6x16 w from rubber buffer e with an Allen key. Remove both
Allen screws r and ignition coil bracket t as well as the 3
with bracket u.
Remove both Allen screws M6x30 i from the distance nut M6 o. After
detaching the double grounding cables P, the double ignition coils p can be
replaced individually. The ignition cables are screwed in and therefore are
renewable.
Except the double ignition coil [ for spark plug 3 and 4
NOTE:
bottom, all are fitted in the same position, with boss ]
upwards.
See Pic. 141, 142
Re-assembly of double ignition coils in reversed sequence.
Attach the double ignition coils offset and in the correct position as per
illustration, with the two Allen screws M6x30 i and lock washers A6 with
distance nut M6 o. Pay attention to the double ignition coil [ for spark plugs
3B and 4B. It must be fitted turned by 180°, compared with the 3 other double
ignition coils (see Pic. 105).
2B
2T
B
T
ws = weiß / white
4B
sw = schwarz / black
4T
4T
A
B
3T
ws
ws
Main
914 F
= unten / bottom
= oben / top
23
3B 2T
A
4B 1T
sw
sw
ws
ws
Reference
rubber buffer y
rd
1B
1T
3B
3T
2B
B
1B
sw
sw
sw
sw
sw
sw
Modification no.
- 0 -