9) Fitting Of Ignition Housing - Rotax 914 F Maintenance Manual

13.3.9) Fitting of ignition housing

6
10
00391
8
Page Date
160 1997 02 01
See Pic. 122 and 123.
If the idle gear W for electric starter has
previously been removed, place thrust
washer Q 12,5/21,5/1 onto the crank-
case. Place idle gear into position and
lubricate idle gear shaft E with motor
oil (see Chapter 13.2.10) and insert it.
Place thrust washer R 12,5/21,5/1 on
top.
Place O-ring 5x2 T into crankcase
and fit guide sleeve, part no. 877 360,
for oil seal onto the crankshaft.
ATTENTION: Without using the guide sleeve, part no. 877 360, the oil seal
will be damaged by the keyway in crankshaft.
Apply LOCTITE 574 sealing compound on the sealing face Y of pre-
assembled ignition cover, apply multi-purpose grease LZ or equivalent
grease onto oil seal U (see Chapter 11.7.3), fit it and turn water pump to
engage in the teeth. Tighten ignition cover with 7 Allen screws M6x30 I and
lock washers evenly to 10 Nm (90 in.lb.).
The Allen screw O M6x30 reaches into the oil compartment
NOTE:
and must be sealed with LOCTITE 221.
P = drive shaft for mechanical rev. counter.
7
9
Pic. 123
Main
914 F
Reference
3
2
1
5
Pic. 122
00390
Modification no.
- 0 -
4