Ricoh SCRIPT2 Setup Manual page 315

AutoNet
Use the set command to configure AutoNet.
msh> set autonet {on|off}
"on" means active and "off" means inactive.
Changing the password
Use the passwd command to change the remote maintenance password.
Important
❒ Be sure not to forget or lose the password.
Note
❒ The default factory password is "password".
A
Type "passwd".
msh> passwd
B
Type the current password.
Old password:
C
Type the new password.
New password:
Note
❒ The password must consist of 3 to 8 alphanumeric characters and symbols.
Upper and lower case characters are considered unique. For example, R is
different from r.
❒ The password is the same as that used in the configuration of the Network
Interface Board using a Web Browser and that used in the NIB Setup Tool.
If you change a password from telnet, the other passwords are also
changed.
D
Type the new password once again.
Retype new password:
Remote Maintenance by telnet
6
89