Ricoh SCRIPT2 Setup Manual page 308

Appendix
❒ For example, if you assign 192.168.15.16 as the Access Control Address of the
Network Interface Board, the IP addresses that can print are as follows. XXX
means any number from 1 to 255 is acceptable.
Access Control Mask
0.
255.
255.255.
255.255.255.
255.255.255.255
❖ ❖ ❖ ❖ Configuration for multiple access controls
msh> access multi {on | off}
"on" means active and "off" means inactive.
msh> access {1 - 5} parameter address
Note
❒ Up to 5 access controls are available. Specify the number (1 - 5) when con-
6
figuring some access controls. If this is not configured, the first setting is
selected.
Network Boot
Use the set command to configure the boot method.
msh> set parameter {on | off}
"on" means active and "off" means inactive.
Parameter
ping
tftp
bootp
dhcp
Note
❒ When you use RARP+TFTP, BOOTP or DHCP, the server also needs to be
configured.
❒ DHCP takes precedence over all other settings.
82
0. 0. 0
0. 0. 0
0. 0
0
Meaning
ARP+PING
RARP+TFTP
BOOTP
DHCP
IP addresses that can access the
printer
XXX.XXX.XXX.XXX
192.XXX.XXX.XXX
192.168.XXX.XXX
192.168. 15.XXX
192.168. 15. 16