Ricoh SCRIPT2 Setup Manual page 332

Appendix
D
Enter your user name and password, and then click [OK].
To use the factory default account, enter no user name and type "password"
for the password.
E
Click [TCP/IP].
F
Set [WINS] to active and enter the IP address of the WINS server in [Primary
WINS Server] and [Secondary WINS Server].
G
Click [Refresh].
H
Exit the Web browser.
I
Restart the printer.
Using telnet
A
Connect to the remote printer using telnet.
B
Use the "set" command to make WINS active.
msh> set wins on
6
C
Specify the IP addresses (primary and secondary) using the following com-
mands.
msh> wins primary IPaddress
msh> wins secondary IPaddress
Note
❒ To confirm the current configuration, use the "show" command.
D
Log out from telnet.
E
Restart the printer.
Using DHCP
You can use the printer under a DHCP environment. You can also register the
printer NetBIOS name on a WINS server when it is running.
Note
❒ Printers that register their NetBIOS name on a WINS server must be config-
ured for the WINS server.
❒ Supported DHCP server is Windows NT 4.0 Server Service Pack 4 or later,
Windows 2000 Server and NetWare 5.
❒ If you do not use WINS server, reserve printer's IP address in DHCP server
so that the same IP address is assigned every time.
106