Removing Reversing Valve Coil - Hitachi RAS-2-HVNP Service Manual

10. Servicing
10.3.3.10 Removing reversing valve coil
1 Remove the service cover following
D A N G E R
DO NOT touch electrical components while the LED1 (Red) is ON to avoid electrical shock. Wait until the LED
turns off.
2 Remove the connector (PCN100) on the control PCB (PCB1) of the electrical box.
3 Remove the reversing valve coil by removing 1 screw fixing the coil.
1. Upper cover.
2. Power Plate.
3. PCN6.
4. Fixing screw for reversing valve coil.
5. Reversing valve coil.
6. Compressor.
7. Reversing valve.
8. Electrical Box.
4 When reassembling, perform the procedure in the reverse way of removing.
N O T E
Fix the wires by plastic bands to the original position.
368
SMGB0079 rev.0 - 01/2013
Removing service cover in this chapter.
8
7
1
2
3
4
5
6