Removing The Compressor - Hitachi RAS-2-HVNP Service Manual

10. Servicing
5 Remove the electrical box cover.
6 Remove the fan motor connector (CN24) inserted into the PCB in the electrical box.
Remove the fan motor lead wire fixed onto the motor clamp using a cord band.
1. Cap nut.
2. Propeller fan.
N O T E
• To mount the motor be sure to place the lead wire outlet downward.
• Fix the motor lead wire onto the motor clamp using a cord band as before to avoid obstructing the propeller
fan.
• Mounting the propeller fan:
• Insert the skidding protection part of the fan boss matching with the motor shaft notch; tighten the nut after
the shaft screw fully comes out. (Tightening Torque 3.0 Nm).
• Connect the motor lead wire to the electrical box PCB. (To connect insert into the connector (CN24) on the
PCB).
10.2.4 Removing the compressor
N O T E
• Do not expose the refrigerant cycle to the atmosphere for a long period to avoid moisture or dust into the cycle.
Be sure to replace the compressor immediately after removing. Seal to the suction and discharge pipes when
the refrigerant cycle is left unattached for a prolonged time.
• Remove the cap of new compressor right before the replacement. Before mounting the compressor seal the
suction and discharge pipes with a tape to protect the compressor from dust. Remove the tape at pipe con-
nection.
• To connect wiring at reassembling ensure that the compressor terminal numbers and wiring mark band codes
are matched. Incorrect wiring numbers may result in inverse rotation and damage the compressor.
1 Remove the pipe cover following
When the outdoor unit is installed close to a wall move the unit from the wall removing the refrigerant piping.
2 Collect the refrigerant from the check joint.
3 Remove the front cover following
325
SMGB0079 rev.0 - 01/2013
Remove 4 screws which fixes the motor.
1. Electrical box cover.
Removing pipe cover.
Removing front cover.
1. Cord band.
2. Fan motor lead wire.
3. Four (4) screws.
4. Fan motor.
10