Hitachi RAS-2-HVNP Service Manual page 281

8. Troubleshooting
(9) No Function
This function is not used.
Press "OK" to proceed.
(10) Transmission Circuit Test
The remote control switch automatically starts to check the
transmission circuit.
(11) Remote Control Switch Thermistor Test
The temperature detected by remote control switch thermistor
A
is displayed at " " in the right figure.
(12) Date/Time Test
The date and time is switched from "2012.03.04 12:34" to "2008.
01. 01 00:00".
(13) EEPROM Test
< EEPROM Clearing Cancel >
Press "?" (help).
< EEPROM Clear >
Press "OK" or wait 15 seconds. EEPROM data will be cleared.
During the process, the numbers will be indicated on where "
" is located.
A
If indicates "999", EEPROM is in a faulty condition.
A
*In case " " indicates "999", the process does not proceed
to next step.
(14) After the several seconds pass, the self checking is completed and the remote control switch automatically restarts.
EEPROM process
(15) Clear EEPROM
The remote control switch will automatically start EEPROM
clearing process.
(16) After the several seconds pass, the self checking is completed and the remote control switch automatically restarts.
267
SMGB0079 rev.0 - 01/2013
Self Checking
0 7 : 0 0 0
Self Checking
0 9 : 0 2 5
Self Checking
1 0 : 0 0 0
Self Checking
1 1 : 0 0 0
A
Self Checking
1 3 : 0 0 0
2008.01.01 00:00
8