Warning Mask - BONFIGLIOLI Act 201 Operating Instructions Manual

14.3.7 Warning Mask

The logic signals of various monitoring and control functions can be set via the opera-
tion mode for parameter
number of warnings and controller status messages can be combined. This enables
internal or external control via a common output signal.
138
138
Create Warning Mask
0 - No Change
1 - Activate everything
2 - Activate all Warnings
Activate all Controller
3 -
States
10 - Warning Ixt
11 - Warning Short-Term Ixt
12 - Warning Long-Term Ixt
Warning Heat Sink Tem-
13 -
perature
Warning
14 -
Inside Temperature
15 - Warning Limit
16 - Warning Init
Warning Motor Tempera-
17 -
ture
Warning
18 -
Phase Failure
Warning
19 -
Motor Protection Switch
20 - Warning Fmax
Warning
21 -
Analog Input MFI1A
Warning
22 -
Analog Input EM-S1INA
Warning
23 -
System bus
24 - Warning Udc
25 - Warning V-belt
Controller
30 -
Udc Dynamic Operation
31 - Controller Shutdown
32 - Controller Mains Failure
Operating Instructions ACTIVE
Operating Instructions ACTIVE
Create Warning Mask
536. According to the application, any
536
Configured warning mask is not modified.
The warnings and controller status messages stated
are linked in the warning mask.
The warnings reports stated are linked in the warn-
ing mask.
The controller status reports stated are linked in the
warning mask.
The frequency inverter is overloaded.
Overload reserve for 1 s minus the
Short-Term Ixt
Overload reserve for 60 s minus the
Long-Term Ixt
Max. heat sink temperature T
Warning Limit Heat Sink Temperature
been reached.
Max. inside temperature T
Warning Limit Inside Temperature
The controller stated in
the reference value.
Frequency inverter is initialized.
Warning behavior according to parameterized
tor Temp. Operation Mode
temperature T
Phase Supervision
Operation Mode
switch has triggered.
Maximum Frequency
The
The frequency limitation is active.
The input signal is lower than 1V/2mA according to
the operation mode
The input signal is lower than 1V/2mA according to
the operation mode
A Slave at the system bus signals a fault;
Warning is only relevant with option EM-SYS.
The DC link voltage has reached the type-
dependent minimum value.
Operation Mode
The
signals no-load operation of the application.
Controller is active according to the
Mode
670 for the voltage controller.
The output frequency in the case of a mains failure
Shutdown Threshold
is below the
Failure of the mains voltage and power regulation
active according to
voltage controller.
Function
Warning Limit
405 has been reached.
Warning Limit
406 has been reached.
of 80 °C minus the
K
of 65 °C minus the
i
408 reached.
Controller Status
570 at max. motor
.
PTC
576 reports a phase failure.
571 for the motor protective
419 has been exceeded.
Error/Warning Behavior
Error/Warning Behavior
581 for V-belt monitoring
Operation
675.
Operation Mode
670 for the
407 has
355 limits
Mo-
453.
453.
06/07
06/07