Speed Controller - BONFIGLIOLI Act 201 Operating Instructions Manual

16.5.3 Speed controller

The source of the actual speed value is selected via parameter
Source
sensor 2 of an extension module is to deliver the actual value signal for the speed
controller, speed sensor 2 must be selected as the source.
1)
The control of the torque-forming current components is done in the outer control
loop by the speed controller. Via parameter
operation mode for the speed controller. The operation mode defines the use of the
parameterizable limits. These are referred to the direction of rotation and the direc-
tion of the torque and depend on the selected configuration.
06/07
06/07
766. By default, speed sensor 1 is used as the actual speed source. If speed
Actual Speed Source
1 - Speed Sensor 1
2 - Speed Sensor 2
Only available if extension module is installed
Operation mode
720
0 - Speed Controller Off
Limits for
1 -
Motor / Generator
Limits for
2 -
pos. / neg. Torque
Operating Instructions ACTIVE
Operating Instructions ACTIVE
766
The actual speed source is speed sensor 1 of the
basic device (factory setting).
The actual speed source is speed sensor 2 of an
extension module.
Operation Mode
The controller is deactivated or the torque-forming
component is zero.
The limitation of the speed controller assigns the up-
per limit to the motor operation of the drive. Inde-
pendent of the direction of rotation, the same limit is
used. The same applies in the case of regenerative
operation with the lower limit.
The assignment of the limit is done by the sign of the
value to be limited. Independent of the motor or gen-
erator operating points of the drive, the positive limi-
tation is done by the upper limit. The lower limit is
regarded as a negative limitation.
Actual Speed
Function
1)
720, you can select the
Function
175
175