BONFIGLIOLI Act 201 Operating Instructions Manual page 143

158 - Timer 1
159 - Timer 2
163 -
164 - Setting Frequency
165 - Warning Ixt
166 -
167 -
168 -
169 - General Warning
170 - Warning Over temperature
171 - Output Comparator 1
172 -
173 - Output Comparator 2
174 -
175 - Digital Signal 1
176 - Digital Signal 2
177 - Digital Signal 3
178 -
179 - Mains Failure
180 -
220 - Logic module 1
221 - Logic module 1 inverted
222 - Logic module 2
223 - Logic module 2 inverted
Table "Operation Modes for Digital Control Signals" continued on next page.
06/07
06/07
Digital Inputs
Reference Frequency
reached
Warning
Heat sink temperature
Warning
Inside temperature
Warning
Motor Temperature
Inverted Output
Comparator 1
Inverted Output
Comparator 2
Reference Percentage
Reached
Warning
Motor Protection Switch
Operating Instructions ACTIVE
Operating Instructions ACTIVE
Function
Output signal of the time function according to
Timer 1
the input connection
Output signal of the time function according to
Timer 2
the input connection
Actual Frequency
Signal when the
reached the reference frequency.
Setting Frequency
Signal when the
Actual Frequency
than or equal to the
The monitoring functions report an overload of
the frequency inverter.
Max. heat sink temperature T
Warning Limit Heat Sink Temp
Max. inside temperature T
Warning Limit Inside Temp.
Warning behavior according to parameterized
Motor Temp. Operation mode
temperature T .
PTC
Warnings
Signal when 269 are displayed with a
critical operating point.
The selected limit values
Temp. Warning Limit Inside Temp
407,
the maximum motor temperature have been ex-
ceeded.
The comparison according to the selected
mode Comparator 1
540 is true.
Operation mode 171 with inverted logic
(LOW active).
The comparison according to the selected
mode Comparator 2
543 is true.
Operation mode 173 with inverted logic
(LOW active).
Signal, according to parameterized
Operation Digital Output 1
Signal according to parameterized
Digital Operation
554 at multi-function output
MFO1.
Signal, according to parameterized
Operation Mode Digital Output 3
Actual Percentage Value
High when the
Reference Percentage Value
reached the
Failure of the mains voltage and power regulation
Operation Mode
active according to
voltage controller.
Operation Mode
Parameterized
protection switch has triggered.
Signal from output of logic module 1, according to
Operation Mode Logic 1
parameterized
Inverted signal from output of logic module 1.
Signal from output of logic module 2, according to
Operation Mode Logic 2
parameterized
Inverted signal from output of logic module 2.
83.
84.
241 has
510 is smaller
241.
of 80 °C less the
K
407 reached.
of 65 °C less the
i
408 reached.
570 at max. motor
Warning Limit Heat Sink
408 or
OP.
OP.
530.
532.
230 has
229.
670 for the
571 of the motor
198.
201.
141
141