Controlling The Motor Via The Control Unit - BONFIGLIOLI Act 201 Operating Instructions Manual

The control unit keys have the following functions:

13.10.3 Controlling the Motor via the Control Unit

The parameter
ence value sources in the frequency reference value channel. Operation modes can be
set without the function "Motorpoti (KP)".
If an operation mode is selected without "Motorpoti (KP)", it is still possible to control
a connected motor via the keys of the KP 500 control unit.
The function is activated as described in "Control Unit KP500, Controlling the Motor via
the Control Unit".
The speed of the modification of the reference value is limited by the parameter
Keypad-Motorpoti
No.
473 Ramp Keypad-Motorpoti
126
126
▲ / ▼
Increase / reduce frequency.
ENT Reversal of the direction of rotation independent of the control signal on
the terminals Clockwise S2IND or Anticlockwise S3IND.
ENT Save the selected function as default value. The direction of rotation is not
(1 sec) exchanged.
ESC Cancel function and return to the menu structure.
FUN Switch from internal set point inP to JOG frequency; the drive starts.
Release the key to switch to the sub-function and stop the drive.
RUN Start drive; alternative to control signal S2IND or S3IND.
STOP Stop drive; alternative to control signal S2IND or S3IND.
Reference Frequency Source
473.
Parameter
Description
Operating Instructions ACTIVE
Operating Instructions ACTIVE
Key functions
475 enables the assignment of the refer-
Min.
0.00 Hz/s 999.99 Hz/s
Ramp
Settings
Max. Fact. sett.
2.00 Hz/s
06/07
06/07