Set-Up Via The Communication Interface - BONFIGLIOLI Act 201 Operating Instructions Manual

7.5
Parameter-setting and commissioning of the frequency inverter via one of the optional
communication interfaces include the plausibility check and the parameter identifica-
tion functions. The parameters can be adjusted by qualified users. The parameter
selection during the guided commissioning procedure includes the basic parameters.
These are based on standard applications of the corresponding configuration and are
therefore useful for commissioning.
Caution!
The parameter
after the selection (if controller release signal is present at digital input S1IND). The
operation modes include functions which are also carried out automatically one after
the other during the guided commissioning procedure.
SETUP Selection
0 - Clear Status
1 - Continue
2 - Abort
10 -
11 -
12 -
13 -
14 -
20 -
21 -
22 -
23 -
24 -
30 -
31 -
32 -
33 -
34 -
82
82

Set-up via the Communication Interface

Parameter settings may only be changed by qualified staff. Before starting
the commissioning process, read the documentation carefully and comply
with the safety instructions.
SETUP Selection
796
The auto set-up routine does not perform a function
The warning message is acknowledged and the auto set-up
routine is continued.
The auto set-up routine is stopped and a RESET of the fre-
quency inverter is performed.
The auto set-up routine is performed in data set 0 and the
Complete Setup,
parameter values are stored in all of the four data sets iden-
DS0
tically.
Complete Setup, The parameter values of the auto set-up are stored in data
DS1 set 1.
Complete Setup, The parameter values of the auto set-up are stored in data
DS2 set 2.
Complete Setup, The parameter values of the auto set-up are stored in data
DS3 set 3.
Complete Setup, The parameter values of the auto set-up are stored in data
DS4 set 4.
Check Machine The auto set-up routine checks the rated motor parameters
Data, DS0 in the four data sets.
Check Machine The rated motor parameters in data set 1 are checked for
Data, DS1 plausibility.
Check Machine The rated motor parameters in data set 2 are checked for
Data, DS2 plausibility.
Check Machine The rated motor parameters in data set 3 are checked for
Data, DS3 plausibility.
Check Machine The rated motor parameters in data set 4 are checked for
Data, DS4 plausibility.
The auto set-up routine determines extended motor data via
Calculation and the parameter identification feature, calculates dependent
Para-Ident., DS0 parameters and stores the parameter values in all of the four
data sets identically.
Calculation and Further motor data are measured, dependent parameters are
Para-Ident., DS1 calculated and the parameter values are saved in data set 1.
Calculation and Further motor data are measured, dependent parameters are
Para-Ident., DS2 calculated and the parameter values are saved in data set 2.
Calculation and Further motor data are measured, dependent parameters are
Para-Ident., DS3 calculated and the parameter values are saved in data set 3.
Calculation and Further motor data are measured, dependent parameters are
Para-Ident., DS4 calculated and the parameter values are saved in data set 4.
Operating Instructions ACTIVE
Operating Instructions ACTIVE
796 defines the function which is carried out directly
Function
06/07
06/07