Table of Contents
Advertisement
5.3
Thanks to the modular hardware components, the frequency inverters can be inte-
grated in the automation concept easily. The standard and optional modules are rec-
ognized during the initialization, and the controller functionality is adjusted automati-
cally. For the information required for installation and handling of the optional mod-
ules, refer to the corresponding documentation.
Danger!
•
•
Attention!
34
34
Optional Components
The hardware modules at slots B and C may only be assembled and dis-
assembled after the frequency inverter has been disconnected safely from
power supply. Wait for some minutes until the DC link capacitors have
discharged before starting the work.
The unit may only be connected with the power supply switched off.
Make sure that the frequency inverter is discharged.
A
Connection of the optional control unit KP500 or an interface
adapter KP232.
B
A
Plug-in section for connection to various communication pro-
tocols:
−
−
−
−
B
C
Slot for customer-specific adaptation of the control inputs
and outputs to various applications:
C
−
−
−
−
If two optional components with CAN-Protocol controller are installed,
the system-bus interface in the EM expansion module is deactivated!
Operating Instructions ACTIVE
Operating Instructions ACTIVE
Hardware modules
Control Unit KP500
Communication module CM
CM-232: RS232 interface
CM-485: RS485 interface
CM-PDP: Profibus-DP interface
CM-CAN: CANopen interface
Expansion module EM
EM-ENC: extended speed sensor evaluation
EM-RES: resolver evaluation
EM-IO: analog and digital inputs and outputs
EM-SYS: system-bus
(system bus in combination with CM-CAN communication
module upon request)
06/07
06/07
Hide quick links:
Advertisement
Table of Contents
