Ip Status - Cisco TelePresence Video Communication Server Administrator's Manual

Field Description
Speed The speed of the connection between the LAN port on the VCS and the Ethernet
switch.
The Ethernet speed can be configured via the

IP status

The IP status page (Status > System >
The following information is displayed:
Field Description
IP section:
Protocol Indicates the IP protocol supported by the VCS.
IPv4: it only accepts registrations from endpoints using an IPv4 address, and will only
take calls between two endpoints or devices communicating via IPv4. It will
communicate with other systems via IPv4 only.
IPv6: it only accepts registrations from endpoints using an IPv6 address, and will only
take calls between two endpoints communicating via IPv6. It will communicate with
other systems via IPv6 only.
Both: it accepts registrations from endpoints using either an IPv4 or IPv6 address, and
takes calls using either protocol. If a call is between an IPv4-only and an IPv6-only
endpoint, the VCS will act as an IPv4 to IPv6 gateway (note that this will require a
traversal call license). The VCS can communicate with other systems via either
protocol.
IPv4 The IPv4 gateway used by VCS.
gateway
IPv6 The IPv6 gateway used by VCS.
gateway
Dual Indicates whether the second LAN port has been enabled. This is done by installing the
Network Dual Network Interfaces option key.
Interfaces
LAN 1 Shows the IPv4 address and subnet mask, and IPv6 address of the LAN 1 port.
LAN 2 If the Dual Network Interfaces option key has been installed, this shows the IPv4
address and subnet mask, and IPv6 address of the LAN 2 port.
DNS section:
Server The IP addresses of each of the DNS servers that are queried when resolving domain
1..5 names. Up to 5 DNS servers may be configured.
address
Domain Specifies the name to be appended to the host name before a query to the DNS server is
executed.
Cisco VCS Administrator Guide (X6.1)
Ethernet page.
IP) shows the current IP settings of the VCS.
Overview and status information
Page 28 of 401