Cisco TelePresence Video Communication Server Administrator's Manual page 297

Reference material
Core Dump Mode: <On/Off>
Controls whether application core dumps are enabled. Note: you must restart the system for any changes to
take effect.
Default: Off
Example: xConfiguration Core Dump Mode: Off
Error Reports Mode: <On/Off>
Determines whether the VCS will automatically send details of application failures to a specified web service.
Default: Off
Example: xConfiguration Error Reports Mode: Off
Error Reports URL: <S: 0, 128>
The URL of the web service to which error reports are sent.
Default: https://vcser.tandberg.com/submitapplicationerror/
Example: xConfiguration Error Reports URL:
"https://vcser.tandberg.com/submitapplicationerror/"
Ethernet [1..2] IP V4 Address: <S: 7,15>
Specifies the IPv4 address of the specified LAN port. Note: you must restart the system for any changes to take
effect.
Example: xConfiguration Ethernet 1 IP V4 Address: "192.168.10.10"
Ethernet [1..2] IP V4 StaticNAT Address: <S:7,15>
If the VCS is operating in static NAT mode, this specifies the external public IPv4 address of that static NAT.
Note: you must restart the system for any changes to take effect.
Example: xConfiguration Ethernet 1 IP V4 StaticNAT Address: "64.22.64.85"
Ethernet [1..2] IP V4 StaticNAT Mode: <On/Off>
Specifies whether the VCS is located behind a static NAT. Note: You must restart the system for any changes
to take effect.
Default: Off
Example: xConfiguration Ethernet 1 IP V4 StaticNAT Mode: On
Ethernet [1..2] IP V4 SubnetMask: <S: 7,15>
Specifies the IPv4 subnet mask of the specified LAN port. Note: you must restart the system for any changes to
take effect.
Example: xConfiguration Ethernet 1 IP V4 SubnetMask: "255.255.255.0"
Cisco VCS Administrator Guide (X6.1) Page 297 of 401