Identifying Calls - Cisco TelePresence Video Communication Server Administrator's Manual

Hide thumbs Also See for TelePresence Video Communication Server:
Table of Contents

Advertisement

Dial plan and call processing

Identifying calls

Each call that passes through the VCS is assigned a Call ID and a Call Serial Number. Calls also
have a Call Tag assigned if one does not already exist.
Call ID
The VCS assigns each call currently in progress a different Call ID. The Call ID numbers start at 1 and
go up to the maximum number of calls allowed on that system.
Each time a call is made, the VCS will assign that call the lowest available Call ID number. For
example, if there is already a call in progress with a Call ID of 1, the next call will be assigned a Call ID
of 2. If Call 1 is then disconnected, the third call to be made will be assigned a Call ID of 1.
The Call ID is not therefore a unique identifier: while no two calls in progress at the same time will have
the same Call ID, the same Call ID will be assigned to more than one call over time.
Note that the VCS web interface does not show the Call ID.
Call Serial Number
The VCS assigns a unique Call Serial Number to every call passing through it. No two calls on a VCS
will ever have the same Call Serial Number. A single call passing between two or more VCSs will be
identified by a different Call Serial Number on each system.
Call Tag
Call Tags are used to track calls passing through a number of VCSs. When the VCS receives a call, it
checks to see if there is a Call Tag already assigned to it. If so, the VCS will use the existing Call Tag;
if not, it will assign a new Call Tag to the call. This Call Tag is then included in the call's details when
the call is forwarded on. A single call passing between two or more VCSs will be assigned a different
Call Serial Number each time it arrives at a VCS (including one it has already passed through) but can
be identified as the same call by use of the Call Tag. This is particularly useful if you are using a
remote syslog server
to collate events across a number of VCSs in your network.
The Call Tag also helps identify loops in your network - it is used as part of the automatic
call loop
detection
feature, and you can also search the Event Log for all events relating to a single call tag.
Loops occur when a query is sent to a neighbor zone and passes through one or more systems before
being routed back to the original VCS. In this situation the outgoing and incoming query will have
different Call Serial Numbers and may even be for different destination aliases (depending on whether
any transforms were applied). However, the call will still have the same Call Tag.
Note: Call Tags are supported by VCS version X3.0 or later. If a call passes through a system that is
not a VCS, or a VCS that is running an earlier version of the software, the Call Tag information will be
lost.
Identifying calls in the CLI
To control a call using the CLI, you must reference the call using either its Call ID or Call Serial
Number. These can be obtained using the command:
xStatus Calls
n
This returns details of each call currently in progress in order of their Call ID. The second line of each
entry lists the Call Serial Number, and the third lists the Call Tag, for example:
Cisco VCS Administrator Guide (X6.1)
Page 153 of 401

Advertisement

Table of Contents
loading

Table of Contents