Cisco TelePresence Video Communication Server Administrator's Manual page 318

Reference material
SIP Require UDP BFCP Mode: <On/Off>
Controls whether the VCS will require the use of the com.tandberg.udp.bfcp extension for endpoints that support
it.
Default: On
Example: xConfiguration SIP Require UDP BFCP Mode: On
SIP Routes Route [1..20] Address: <S:0,39>
Specifies the IP address of the next hop for this route, where matching SIP requests will be forwarded.
Note: this command is intended for developer use only.
Example: xConfiguration SIP Routes Route 1 Address: "127.0.0.1"
SIP Routes Route [1..20] Authenticated: <On/Off>
Whether to forward authenticated requests.
On: only forward requests along route if incoming message has been authenticated.
Off: always forward messages that match this route.
Default: Off
Note: this command is intended for developer use only.
Example: xConfiguration SIP Routes Route 1 Authenticated: On
SIP Routes Route [1..20] Header Name: <S:0,64>
Name of SIP header field to match (e.g. Event).
Note: this command is intended for developer use only.
Example: xConfiguration SIP Routes Route 1 Header Name: "Event"
SIP Routes Route [1..20] Header Pattern: <S:0,128>
Regular expression to match against the specified SIP header field.
Note: this command is intended for developer use only.
Example: xConfiguration SIP Routes Route 1 Header Pattern: "(my-event-
package)(.*)"
SIP Routes Route [1..20] Method: <S:0,64>
SIP method to match to select this route (e.g. INVITE, SUBSCRIBE).
Note: this command is intended for developer use only.
Example: xConfiguration SIP Routes Route 1 Method: "SUBSCRIBE"
Cisco VCS Administrator Guide (X6.1) Page 318 of 401