Cisco TelePresence Video Communication Server Administrator's Manual page 327
Hide thumbs
Also See for TelePresence Video Communication Server:
- Command reference manual (95 pages)
Table of Contents
Advertisement
Reference material
Zones LocalZone DefaultSubZone Bandwidth PerCall Inter Mode: <Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in the Default
Subzone.
NoBandwidth: no bandwidth available. No calls can be made to or from the Default Subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Inter
Mode: Limited
Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Limit: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call between two endpoints within the Default Subzone
(applies only if the mode is set to Limited).
Default: 1920
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Intra
Limit: 1920
Zones LocalZone DefaultSubZone Bandwidth PerCall Intra Mode: <Limited/Unlimited/NoBandwidth>
Determines whether there is a limit on the bandwidth for any one call between two endpoints within the Default
Subzone.
NoBandwidth: no bandwidth available. No calls can be made within the Default Subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth PerCall Intra
Mode: Limited
Zones LocalZone DefaultSubZone Bandwidth Total Limit: <1..100000000>
Sets the total bandwidth limit (in kbps) of the Default Subzone (applies only if Mode is set to Limited).
Default: 500000
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth Total Limit:
500000
Zones LocalZone DefaultSubZone Bandwidth Total Mode: <Limited/Unlimited/NoBandwidth>
Determines whether the Default Subzone has a limit on the total bandwidth being used by its endpoints at any
one time.
NoBandwidth: no bandwidth available. No calls can be made to, from, or within the Default Subzone.
Default: Unlimited
Example: xConfiguration Zones LocalZone DefaultSubZone Bandwidth Total Mode:
Limited
Zones LocalZone DefaultSubZone Registrations: <Allow/Deny>
Controls whether registrations assigned to the Default Subzone are accepted.
Default: Allow
Example: xConfiguration Zones LocalZone DefaultSubZone Registrations: Allow
Cisco VCS Administrator Guide (X6.1)
Page 327 of 401
Advertisement
Table of Contents
