Cisco TelePresence Video Communication Server Administrator's Manual page 303

Reference material
IPProtocol: <Both/IPv4/IPv6>
Selects whether the VCS is operating in IPv4, IPv6 or dual stack mode. Note: you must restart the system for
any changes to take effect.
Default: IPv4
Example: xConfiguration IPProtocol: IPv4
LDAP Encryption: <Off/TLS>
Sets the encryption to use for the connection to the LDAP server.
Off: no encryption is used.
TLS: TLS encryption is used.
Default: Off
Example: xConfiguration LDAP Encryption: Off
LDAP Password: <S: 0, 122>
Sets the password to use when binding to the LDAP server. The maximum plaintext length is 60 characters,
which is then encrypted.
Example: xConfiguration LDAP Password: "password123"
LDAP Server Address: <S: 0, 128>
Sets the IP address or Fully Qualified Domain Name (FQDN) of the LDAP server to use when making LDAP
queries.
Example: xConfiguration LDAP Server Address: "ldap.server.example.com"
LDAP Server Port: <1..65534>
Sets the IP port of the LDAP server to use when making LDAP queries. Typically, non-secure connections use
389 and secure connections use 636.
Default: 389
Example: xConfiguration LDAP Server Port: 389
LDAP UserDN: <S: 0, 255>
Sets the user distinguished name to use when binding to the LDAP server.
Example: xConfiguration LDAP UserDN: "user123"
Log Level: <1..4>
Controls the granularity of Event Logging. 1 is the least verbose, 4 the most.
Note: this setting is not retrospective; it will determine which events are written to the Event Log from now
onwards.
Default: 1
Example: xConfiguration Log Level: 1
Cisco VCS Administrator Guide (X6.1) Page 303 of 401