Cisco TelePresence Video Communication Server Administrator's Manual page 294

Reference material
Authentication LDAP BaseDN: <S: 0, 255>
Specifies the Distinguished Name to use when connecting to an LDAP server.
Example: xConfiguration Authentication LDAP BaseDN: "dc=example,dc=company,dc=com"
Authentication Password: <S: 0, 215>
The password used by the VCS when authenticating with another system. The maximum plaintext length is 128
characters, which is then encrypted. Note: this does not apply to traversal client zones.
Example: xConfiguration Authentication Password: "password123"
Authentication UserName: <S: 0, 128>
The username used by the VCS when authenticating with another system. Note: this does not apply to traversal
client zones.
Example: xConfiguration Authentication UserName: "VCS123"
Bandwidth Default: <64..65535>
Sets the bandwidth (in kbps) to be used on calls managed by the VCS in cases where no bandwidth has been
specified by the endpoint.
Default: 384
Example: xConfiguration Bandwidth Default: 384
Bandwidth Downspeed PerCall Mode: <On/Off>
Determines whether or not the VCS will attempt to downspeed a call if there is insufficient per-call bandwidth
available to fulfill the request.
On: the VCS will attempt to place the call at a lower bandwidth.
Off: the call will be rejected.
Default: On
Example: xConfiguration Bandwidth Downspeed PerCall Mode: On
Bandwidth Downspeed Total Mode: <On/Off>
Determines whether or not the VCS will attempt to downspeed a call if there is insufficient total bandwidth
available to fulfill the request.
On: the VCS will attempt to place the call at a lower bandwidth.
Off: the call will be rejected.
Default: On
Example: xConfiguration Bandwidth Downspeed Total Mode: On
Bandwidth Link [1..3000] Name: <S: 1, 50>
Assigns a name to this link.
Example: xConfiguration Bandwidth Link 1 Name: "HQ to BranchOffice"
Cisco VCS Administrator Guide (X6.1) Page 294 of 401