Cisco TelePresence Video Communication Server Administrator's Manual page 367

SubZoneAdd
Adds and configures a new subzone.
SubZoneName(r): <S: 1, 50>
Assigns a name to this subzone.
TotalMode: <Unlimited/Limited/NoBandwidth>
Determines whether this subzone has a limit on the total bandwidth of calls being used by its endpoints at any one
time. NoBandwidth: no bandwidth available. No calls can be made to, from, or within this subzone. Default:
Unlimited.
Total: <1..100000000>
Sets the total bandwidth limit (in kbps) of this subzone (applies only if the mode is set to Limited). Default: 500000.
PerCallInterMode: <Unlimited/Limited/NoBandwidth>
Sets bandwidth limits for any one call to or from an endpoint in this subzone. NoBandwidth: no bandwidth
available. No calls can be made to or from this subzone. Default: Unlimited.
PerCallInter: <1..100000000>
Specifies the bandwidth limit (in kbps) on any one call to or from an endpoint in this subzone (applies only if the
mode is set to Limited). Default: 1920.
PerCallIntraMode: <Unlimited/Limited/NoBandwidth>
Sets bandwidth limits for any one call between two endpoints within this subzone. NoBandwidth: no bandwidth
available. No calls can be made within this subzone. Default: Unlimited.
PerCallIntra: <1..100000000>
Specifies the bandwidth limit (in kbps) for any one call between two endpoints within this subzone (applies only if
the mode is set to Limited). Default: 1920.
Example: xCommand SubZoneAdd SubZoneName: "BranchOffice" TotalMode: Limited Total:
1024 PerCallInterMode: Limited PerCallInter: 512 PerCallIntraMode: Limited
PerCallIntra: 512
SubZoneDelete
Deletes a subzone.
SubZoneId(r): <1..1000>
The index of the subzone to be deleted.
Example: xCommand SubZoneDelete SubZoneId: 2
Cisco VCS Administrator Guide (X6.1)
Reference material
Page 367 of 401