Cisco TelePresence Video Communication Server Administrator's Manual page 284

ID Warning message
10035 Cluster replication error: cannot find master or this peer's
configuration file, manual synchronization of configuration is
required
10036 Cluster replication error: this peer's configuration conflicts
with the master's configuration, manual synchronization of
configuration is required
10037 Cluster replication error: the Master peer is unreachable
10038 Cluster replication error: the local VCS does not appear in the
list of peers
10039 Cluster replication error: there was an error during automatic
replication of configuration
10040 Cluster replication error: automatic replication of configuration
has been temporarily disabled because an upgrade is in
progress
10041 Cluster name not configured: if FindMe or clustering are in use
a cluster name must be defined
10042 Invalid clustering configuration: H.323 mode must be turned
On - clustering uses H.323 communications between peers
10043 LDAP Configuration required: a valid Server Address, Server
Port, BindDN and BaseDN are required if remote login
authentication is used for administrator or FindMe users
10044 TURN relays installed: TURN services are only available on
VCS Expressway; TURN option key ignored
10045 TURN relay licenses required: TURN services are enabled
but no TURN relay license option keys are installed
10046 An Ethernet interface speed setting has been negotiated to a
value other than 1000Mb/s full duplex or 100Mb/s full duplex.
This may result in packet loss over your network
10047 Restart required: QoS settings have been changed, however
a restart is required for this to take effect
10048 Restart required: the TMS Agent service has stopped
unexpectedly. If the problem persists, contact your Cisco
support representative
10049 Reboot required: the advanced account security mode has
changed, however a reboot is required for this to take effect
10050 Time out period required: a non-zero system session time out
period is required when in advanced account security mode
Cisco VCS Administrator Guide (X6.1)
Reference material
Resolution
View cluster replication
troubleshooting instructions
View cluster replication
troubleshooting instructions
Check the list of peers for
this cluster
Check the list of peers for
this cluster
View cluster replication
troubleshooting instructions
Wait until the upgrade has
completed
Configure the cluster name
Configure H.323 mode
Configure LDAP parameters
Add/Remove option keys
Add option key or disable
TURN services
Configure Ethernet
parameters
Restart the VCS
Restart the VCS
Reboot the VCS
Configure session time out
period
Page 284 of 401