Warnings List - Cisco TelePresence Video Communication Server Administrator's Manual

Warnings list

Warnings occur when an event or configuration change has taken place on the VCS that requires
some manual administrator intervention, such as a restart. Warnings may also be raised for hardware
and environmental issues such as faulty disks and fans or high temperatures.
The Warnings page (Status >
system (and, where applicable, their proposed resolution). When there are unacknowledged warnings
in place on the VCS, a warning icon
The following table lists the warnings that can be raised on the VCS.
ID Warning message
10001 Configuration warning: expected default link between the
Default Subzone and the Traversal Subzone is missing
10002 Configuration warning: expected default link between the
Default Subzone and the Default Zone is missing
10003 Configuration warning: expected default link between the
Default Subzone and the Cluster Subzone is missing
10004 Configuration warning: expected default link between the
Traversal Subzone and the Default Zone is missing
10005 Port conflict: one or more ports have been configured for use
by more than one service
10006 Configuration warning: IP protocol is set to both IPv4 and
IPv6, but the VCS does not have any IPv6 addresses defined
10007 Configuration warning: IP protocol is set to both IPv4 and
IPv6, but the VCS does not have any IPv4 addresses defined
10008 Configuration warning: IP protocol is set to both IPv4 and
IPv6, but the VCS does not have an IPv4 gateway defined
10009 Configuration warning: IP protocol is set to both IPv4 and
IPv6, but the VCS does not have an IPv6 gateway defined
10010 Restart required: Ethernet configuration has been changed,
however a restart is required for this to take effect
10011 Restart required: HTTP service has been changed, however a
restart is required for this to take effect
10012 Restart required: HTTPS service has been changed, however
a restart is required for this to take effect
10013 Restart required: IP configuration has been changed, however
a restart is required for this to take effect
10014 Restart required: port configuration has been changed,
however a restart is required for this to take effect
10015 Configuration warning: H.323 and SIP modes are set to Off;
one or both of them should be enabled
Cisco VCS Administrator Guide (X6.1)
Warnings) provides a list of all the warnings currently in place on your
appears at the top right of all pages.
Reference material
Resolution
Configure default links
Configure default links
Configure default links
Configure default links
Review the port
configuration
Configure IP settings
Configure IP settings
Configure IP settings
Configure IP settings
Restart the VCS
Restart the VCS
Restart the VCS
Restart the VCS
Restart the VCS
Configure H.323 and/or SIP
modes
Page 282 of 401